The following parts are produced in small quantities.There is usually one in stock of each of the smaller items. The items are made in batches over the year so there may be a wait until the next batch of spares is ready.
Availability : limited number available
Parking Light chromed complete with lens unit,screws and contact/wire,
Availability : 1 pair only
Price : P.O.A
Side panels for the Leader in fibre glass, approx. one third the weight of the metal ones.
. thread 3/8 unf
Plastic suspension caps- ivory ( Arrow )
Availability : 8
Price : £9-00 each
I have a few in clear and dark blue plastic,also some seconds with colour faults, in ivory and light blue (L A G ), these cost less.
Bush for assembling chain case, prevents damage to oil seal.
Locating plate and Pin.
Availability : 1
Price : £ 20-00
Locating plate and pin (for splitting cranks). Cast type £42-00 when available
For undoing clutch center nut
Hexagonal key 3/8″ for faster cylinder head bolt undoing.
Washers for supplementary springs T 1123
Cupped washer in polished St/ Steel – T 1564.
Choke operating linkage for Arrow with white plastic end.
Choke operating linkage for Leader with white plastic end.
Mirror Brackets for Leader front shield in stainless steel.
Petrol Tap with reserve for Arrow includes the filter and thin washers to help get the tap to the correct position. (the Arrow Tap can be supplied chrome plated for an extra £6.)
Petrol Tap with reserve for Leader includes the filter and thin washers to help get the tap to the correct position.
Extractor for removing fly wheel and end covers – includes bush to protect end of main shaft and enable the oil seal in the chaincase to go over the shaft peg without damage.
Screw, distance piece and stay bolt.Three pieces to make up the fastener for each side of the screen.
Bolt and Knurled nut for screen extension.
Parcel Locker Liner – Availability : 1 for Leader ; 1 for Arrow
Price : see below
Liner for the Leader parcel locker, includes the clips to hold it in place £ 16-00
The Arrow uses just the diamond piece to cover the coil access £ 4-00
Ball & Bush For Anchor Bar
The variation in size of the anchor bar socket due to wear/rust is over 15 thou ( 0.015 ). The only practical way to ensure a good fit is to make the nylon bushes individually to fit the actual socket. Cost £5-00 each bush. I will need the anchor bar to fit the bushes.
VARIOUS OTHER ITEMS ARE IN THE PROCESS OF BEING MADE OR ARE MADE OCCASIONALLY
– Bush for fitting compression seals on to main shafts
– Little end extraction tool
– Flywheel strap
– Nylon handle bar spacers
– Top pressing seat screw protector
– Fibre glass pannier lid ( metal lids can be made by a firm in Manchester but they are .. expensive and you still need to find some locks )
-Alloy cylinders– long term project
– Arrow carrier – limited number available
-Leader inspection light